Reset Search
 

 

Article

How to configure either an in-band or an out-of-band management interface.

« Go Back

Information

 
TitleHow to configure either an in-band or an out-of-band management interface.
Objective
  • How to configure either an in-band or an out-of-band management interface
Environment
  • VSP
  • All versions
Procedure
  • Configure an in-band management IP interface and VLAN

Note: The following procedure uses VLAN 20 and IP address

198.51.100.17 as an example.

1. Create a VLAN:
VSP-switch:1(config)# vlan create 20 type port-mstprstp 0
2. Add VLAN members:
VSP-switch:1(config)# vlan members add 20 1/1-1/4
3. Activate ports:
VSP-switch:1(config)# interface gigabitEthernet1/1-1/4
VSP-switch:1(config-if)# no shutdown
4. Configure an IP interface for the VLAN:
VSP-switch:1(config)# interface vlan 20
VSP-switch:1(config)# ip address 198.51.100.17 255.255.255.0
5. Add a static route:
VSP-switch:1(config)# ip route 198.0.0.0 255.0.0.0 198.51.100.1 weight 1
  • Configure an out-of-band management IP interface and VLAN
1. Configure the management interface:
VSP-switch:1(config)# interface mgmtEthernet mgmt
VSP-switch:1(config-if)# ip address 198.51.100.17/24
2. Configure static routes:
VSP-switch:1(config)# router vrf mgmtrouter
VSP-switch:1(config-vrf)# ip route 198.0.0.0 255.0.0.0 198.51.100.1 weight 1

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255