Reset Search
 

 

Article

How to Configure LACP on an 800-Series Switch Thru CLI

« Go Back

Information

 
TitleHow to Configure LACP on an 800-Series Switch Thru CLI
Objective
How to Configure LACP on an 800-Series Switch Thru CLI
Environment
  • 800-Series
  • Firmware version 01.03.xx.xxxx or Higher
  • Link Aggregation Control Protocol (LACP)
Procedure
The following example outlines the necessary steps to configure LACP on an 800-Series solution  
create link_aggregation group_id 1 type lacp
config link_aggregation group_id 1 mater_port 23 ports 23-24 state enable
config lacp_port 23-24 mode active


 
Additional notes
Please refer to chapter 36 of the CLI Reference Guide of the Extreme 800-Series (Legacy Enterasys 800-Series) for more information about the command lines used in the example above. 

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255