Reset Search
 

 

Article

How To Configure a Securestack to Route Multicast Using DVMRP?

« Go Back

Information

 
TitleHow To Configure a Securestack to Route Multicast Using DVMRP?
Objective
How to configure DVMRP to route Multicast on a Securestack
Environment
Securestack
Procedure
1. Configure IGMP on the port level
set igmpsnooping interfacemode lag.0.5 enable
set igmpsnooping interfacemode lag.0.6 enable
2. Enable IGMP snooping globally
set igmpsnooping adminmode enable

3. Enable IGMP Blobally under the router config
#Router Configuration
router
enable
configure
ip igmp

4. Enable DVMRP globally in router mode
ip dvmrp

5. Configure DVMRP to enable routing and IGMP to make it a querier on interfaces where multicast should be routed
interface vlan 1
ip address 192.168.0.211 255.255.255.0
ip dvmrp enable
ip igmp enable
no shutdown
exit
interface vlan 30
ip address 192.168.30.1 255.255.255.0
no shutdown
exit
interface vlan 3030
ip address 30.30.0.254 255.255.0.0
ip dvmrp enable
ip igmp enable
no shutdown
exit
Additional notes
Configuring IGMP means you do not need to configure the switch to be a querier in the layer two config.

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255