Reset Search
 

 

Article

How To Configure the Service Port on a 200-Series switch?

« Go Back

Information

 
TitleHow To Configure the Service Port on a 200-Series switch?
Objective
How to configure the Service Port on a 200-Series switch?
Environment
  • 200-Series
  • All firmware versions
Procedure
Via CLI:
(Extreme 220) >enable

(Extreme 220) #serviceport protocol none

Changing protocol mode will reset ip configuration.
Are you sure you want to continue? (y/n) y

(Extreme 220) #serviceport ip <IP_ADDRESS> <NETWORK_MASK> <DEFAULT_GATEWAY>

Via Web UI:

System > Connectivity > Service Port IPv4

User-added image

 
Additional notes
  • The Service Port is a dedicated Ethernet port used for out-of-band management.
  • By default, the Service Port is looking for a DHCP address.
  • There is no VLAN associated to the Service Port.

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255