Reset Search
 

 

Article

How to Configure IGMP Querier and Snooping on G-Series Switches

« Go Back

Information

 
TitleHow to Configure IGMP Querier and Snooping on G-Series Switches
Objective
This document explain how to configure IGMP querier and IGMP snooping on G-Series switches
Environment
  • G-Series
  • All firmware versions
Procedure
  1. Globally Enable L2 IGMP Snooping
G3(su)->set igmpsnooping adminmode enable
  1. ​Enable L2 IGMP Snooping on Target Interfaces
G3(su)->set igmpsnooping interfacemode ge.1.1-10 enable
  1. ​Configure IGMP L3 Querier
G3(su)->router
G3(su)->router>enable
G3(su)->router#configure
Enter configuration commands:
G3(su)->router(Config)# ip igmp
  1. Enable IGMP L3 Querying on Target VLAN Interfaces​
G3(su)->router(Config)#interface vlan 10
G3(su)->router(Config-if(Vlan 10))#ip igmp enable
G3(su)->router(Config-if(Vlan 10))#exit
G3(su)->router(Config)#exit
G3(su)->router#

Additional notes
For IGMP configuration on S/N/K-Series and SecureStack please refer to the article How To Configure IGMP Snooping and IGMP Querier on S-Series, K-Series, N-Series, and SecureStacks

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255