Reset Search
 

 

Article

How to Configure an 802.1Q Trunk on XSR Router

« Go Back

Information

 
TitleHow to Configure an 802.1Q Trunk on XSR Router
Objective
How to Configure an 802.1Q Trunk on XSR Router
Environment
  • XSR
  • Firmware 7.5.0.0 and later
Procedure
  • firmware 7.5.0.0 and allows the XSR to forward tagged packets and provide QoS based on the P bit.The XSR is Q-trunk aware as of
  • The XSR will not switch between interfaces and forwards only packets that need to be routed. The configuration is a matter of assigning a VLAN to each routed (sub-)interface, with VLAN-tagging assumed.
  • The following example configures a FastEthernet sub-interface with VLAN ID 10:
XSR(config)#interface fastethernet 2.1
XSR(config-if<f2.1>)#vlan 10
XSR(config-if<f2.1>)#ip address 1.2.3.4 255.255.255.0
XSR(config-if<f2.1>)#no shutdown
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255