Reset Search
 

 

Article

How to Connect by Console to a Summit WM3000 Series Wireless Controller

« Go Back

Information

 
TitleHow to Connect by Console to a Summit WM3000 Series Wireless Controller
Objective
To add the Summit WM wireless controller to the network and prepare it for initial configuration
Environment
  • Summit WM3000 series controller
Procedure
  • Using the supplied console cable connect the Summit WM wireless controller serial port to an RS-232 (DB-9) serial port on a separate computer (the “configuration computer”).
  • The pinout for the RJ-45 to DB9 cable is shown in the following table.
 
RJ-451234,5678
DB98625347
 
  •  On the configuration computer, configure a terminal emulation application (such as HyperTerminal) as follows:
 
Terminal TypeVT-100 
PortCOM port
Terminal Settings19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255