Reset Search
 

 

Article

How to add a PV-FC-180 to Extreme Management Center Analytics

« Go Back

Information

 
TitleHow to add a PV-FC-180 to Extreme Management Center Analytics
Objective
  • To add a PV-FC-180 To Extreme Management Center Analytics using the applications tab,
  • Adding PV-FC-180 to Analytics without using CLI.

 
Environment
  • PV-FC-180
  • Extreme Management Center
  • Analytics

 
Procedure

From Extreme Management Center

Analytics->Configuration->Engines->Select Engine->Configuration

Scroll to flow sources and click Add

Add Flow Source IP (PV-FC-180 IP address)

Select Source Ports (ones that will be looking at traffic)

Destination port, typically use a tunnel port to save on front panel port space. However a physical port can be used. It would directly connect to the Analytics appliance eth1 or other non eth0 port.

User-added image

Shows port selection for source. Make sure to not use your uplink port to the network.
User-added image

Select Mirror Destination Port. Tunnel port is recommended, as it saves a physical front panel port.
User-added image

To do this, make sure to also click enable tunneling checkbox,
The Tunnel IP is the local IP of the PV-FC-180. A seperate IP can be used, and will be programmed in as a loopback.
User-added image

The below screenshots shows the device added as a flow source successfully. 
User-added image



 
Additional notes
The software that supports this feature is 8.1.2.xx
An ip address will need to be added to the PV-FC-180
use 'set ip address X.X.X.X mask 255.255.255.0 interface vlan.0.1 gateway X.X.X.X'

Below is a sample output configuration from PV-FC-180 after configuration (some defaults removed) for the recommended tunnel configuration.



begin
!
# ***** NON-DEFAULT CONFIGURATION *****
!
!

configure terminal
!
 interface vlan.0.1
  ip address 10.X.X.X.X 255.255.255.252 primary
  no ip proxy-arp
  no ip forwarding
  no shutdown
  exit
 interface tun.0.1
  tunnel destination 10.58.25.92
  tunnel mode gre l2 tbp.0.1
  tunnel mirror enable
  tunnel source 10.58.255.246
  no shutdown
  exit
!
# Static routes configured on non-routed interfaces
 ip route 0.0.0.0/0 10.X.X.241 interface vlan.0.1 1
!
exit
!
# ip dns
!
# ip interface
set ip interface vlan.0.1 default
!
# mirror
set mirror create 1
set mirror 1 mirrorN 15
set mirror ports tbp.0.1 1
!
# netflow
set netflow export-interval 1
set netflow export-destination 10X.X.X.X 2055
set netflow export-version 9
set netflow port tg.1.2 enable rx
set netflow template refresh-rate 30 timeout 1
set netflow cache enable

!
# policy
set policy profile 1 name EMC_FS_Mirror pvid-status enable pvid 0 mirror-destination 1
set policy rule admin-profile port tg.1.2 mask 16 port-string tg.1.2 admin-pid 1
!
# port
set port jumbo enable tg.1.1
set port jumbo enable tg.1.2
set port jumbo enable tg.1.3
set port jumbo enable tg.1.4
!

!
# timezone
!
# tunnel
!
# vlan
!
end



 

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255