Reset Search
 

 

Article

How to configure 200-Series for VLAN Tagging / Trunking on uplink or downlink interfaces

« Go Back

Information

 
TitleHow to configure 200-Series for VLAN Tagging / Trunking on uplink or downlink interfaces
Objective
How to configure VLAN Tagging / Trunking on uplink or downlink interfaces
Environment
  • 200-Series
  • All firmware versions
  • Uplink / Downlink ISL Trunking
  • VLAN Tagging
Procedure
     1.  VLAN must be created in the VLAN database:
(Extreme 220) >enable
(Extreme 220) #vlan database
(Extreme 220) (Vlan)#vlan 10,20,30
(Extreme 220) (Vlan)#exit
     2.  To enable tagging, you need to enable trunk mode on the interface:
(Extreme 220) #config
(Extreme 220) (Config)#interface 1/0/2
(Extreme 220) (Interface 1/0/2)#vlan tagging 10,20,30
(Extreme 220) (Interface 1/0/2)#vlan participation include 10,20,30
(Extreme 220) (Interface 1/0/2)#exit
(Extreme 220) (Config)# exit
     3.  Ensure to save configuration which copies running-config to startup-config:
write memory confirm






Optionally, VLAN tagging can also be configured by use of trunk mode option, which works identical to above command example:
(Extreme 220) #config
(Extreme 220) (Config)#interface 1/0/2
(Extreme 220) (Interface 1/0/2)#switchport mode trunk
(Extreme 220) (Interface 1/0/2)#switchport trunk allowed vlan 10
(Extreme 220) (Interface 1/0/2)#switchport trunk allowed vlan add 20,30
(Extreme 220) (Interface 1/0/2)#exit 
(Extreme 220) (Config)# exit

(Extreme 220) #write memory confirm

Additional notes
See also: How to configure 200-Series with untagged VLAN for access ports


To view all ports on a switch, issue command:
show port all

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255