Reset Search
 

 

Article

How to configure 200-Series with untagged VLAN for access ports

« Go Back

Information

 
TitleHow to configure 200-Series with untagged VLAN for access ports
Objective
  • How to configure 200-Series with untagged VLAN for access ports
  • Same configuration can be used for native / untagged VLAN on uplink or ISL ports
  • Each port can only have one PVID (untagged VLAN) assigned at a time
Environment
  • 200-Series
  • All firmware versions
  • Untagged VLAN 
  • Access VLAN
Procedure
     1.  VLAN must be created in the VLAN database:
(Extreme 220) >enable
(Extreme 220) #vlan database
(Extreme 220) (Vlan)#vlan 999
(Extreme 220) (Vlan)#exit
     2.  Enter config mode and go into port that needs configuration:
(Extreme 220) #config
(Extreme 220) (Config)#interface 1/0/2
(Extreme 220) (Interface 1/0/2)#vlan tagging 999
(Extreme 220) (Interface 1/0/2)#vlan participation include 999
(Extreme 220) (Interface 1/0/2)#exit
(Extreme 220) (Config)# exit
(Extreme 220) #write memory confirm

 





Optionally, VLANs can be set to untagged through switchport access mode option, which works identical to above command example:
(Extreme 220) #config
(Extreme 220) (Config)#interface 1/0/2
(Extreme 220) (Interface 1/0/2)#switchport mode access
(Extreme 220) (Interface 1/0/2)#switchport access vlan 999
(Extreme 220) (Interface 1/0/2)#exit
(Extreme 220) (Config)# exit
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255