Reset Search
 

 

Article

How to configure DHCP server on 200-series switch

« Go Back

Information

 
TitleHow to configure DHCP server on 200-series switch
Objective
How to configure DHCP server on 200-series switch
Environment
  • 200-Series
  • All Firmware Versions
  • DHCP Server Configuration
Procedure
Example Configuration for DHCP Server:
(Extreme 220) #configure
(Extreme 220) (Config)#service dhcp
(Extreme 220) (Config)#ip dhcp pool vlan-10-pool
(Extreme 220) (Config-dhcp-pool)#default-router <DEFAULT_GATEWAY_IP> 
(Extreme 220) (Config-dhcp-pool)#dhs-server <DNS_SERVER_1> <DNS_SERVER_2>
(Extreme 220) (Config-dhcp-pool)#lease <DAYS> <HOURS> <MINUTES>
(Extreme 220) (Config-dhcp-pool)#network <NETWORK_ADDRESS> <SUBNET_MASK>
Additional notes
To view DHCP Leases issue command:
show ip dhcp bindings
To view other DHCP statistics issue a question mark after the "show ip dhcp" command for available syntax to view:
(Extreme 220) #show ip dhcp ?

binding                  Display DHCP server bindings.
conflict                 Display address conflicts detected by DHCP server.
global                   Display Global Configuration parameters.
pool                     Display DHCP Pool Configuration parameters.
server                   Display DHCP server statistics.
snooping                 Display DHCP snooping configuration.

(Extreme 220) #

 

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255