Reset Search
 

 

Article

How to configure PBR on EXOS or EOS switches for NAC integration

« Go Back

Information

 
TitleHow to configure PBR on EXOS or EOS switches for NAC integration
Objective
Migration from EOS N-Series or S-Series to Extreme EXOS switches, where the EOS device is using a "routemap" to NAC redirect
 
Environment
  • N-Series
  • S-Series
  • Netsight NAC
  • EXOS firmware 15.3.x 16.x
Procedure
Sample EOS configuration
access-list 111 permit tcp any any eq 80 dscp 16

!
route-map 101 permit 10
  match ip address 111
  set next-hop 192.168.30.35
!
interface vlan 3
  ip address 192.168.3.1 255.255.255.0
  ip helper-address  192.168.30.207
  ip policy route-map 101
  no shutdown
!

Sample EXOS configuration
edit policy flowpolicy.pol
 
entry my_flow_entry {
if {
protocol tcp;
destination-port 80;
dscp 16;
}      then {
redirect 192.168.200.35;
}
}
config access-list flowpolicy vlan VLAN3 ingress
enable diffserv examination port 5
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255