Reset Search
 

 

Article

How to configure a VDX port to be an access port for a particular VLAN

« Go Back

Information

 
TitleHow to configure a VDX port to be an access port for a particular VLAN
Objective
Enable port on a VDX to switch for desired VLAN.  This article will cover the steps to configure an access port (as opposed to a trunk port), which can only carry one VLAN.
Environment
VDX
All firmware versions
Procedure
  • First, create the desired VLAN (in this case, VLAN 1010):
switch(config)# interface vlan 1010
 
  • Next, configure the desired port as an access port for this VLAN (in this case, port 1 on rbridge 1):
switch(config)# interface tengigabitethernet 1/0/1
switch(conf-if-te-0/1)# switchport
switch(conf-if-te-0/1)# switchport mode access
switch(conf-if-te-0/1)# switchport access vlan 1010
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255