Reset Search
 

 

Article

How to configure the default gateway for the management interface.

« Go Back

Information

 
TitleHow to configure the default gateway for the management interface.
Objective
To configure the default gateway for the management interface.
Environment
  • VDX
  • Network OS
Procedure
  1. After logging into the CLI, enter the configuration mode terminal by typing configure
  2. Type rbridge-id <id> to enter the rbridge context. The id is the rbridge-id of the switch you are trying to configure and can be seen with show vcs
  3. Type vrf mgmt-vrf to enter the mgmt-vrf context.
  4. Type address-family ipv4 unicast to enter this context.
  5. This is where you can configure the default gateway for the management interface/mgmt-vrf on the switch. Type ip route 0.0.0.0/0 <default gateway IP address>
Additional notes
sw0# configure
Entering configuration mode terminal
sw0(config)# rbridge-id 7
sw0(config-rbridge-id-7)# vrf mgmt-vrf
sw0(config-vrf-mgmt-vrf)# address-family ipv4 unicast
sw0(vrf-mgmt-vrf-ipv4-unicast)# ip route 0.0.0.0/0 10.10.10.10

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255