Reset Search
 

 

Article

How to copy and load a backed up config on S-Series

« Go Back

Information

 
TitleHow to copy and load a backed up config on S-Series
Objective
How to copy and load a backed up config on S-Series
Environment
N-Series
S-Series
K-Series
7100-Series
Procedure
  1. Set up a TFTP server that is reachable by the switch via IP connectivity.
  2. Place the backed up config file in the root directory of the TFTP server
  3. Be sure to turn off any firewalls on the TFTP server PC as this will likely block TFTP traffic
  4. run the following commands on the switch
S-Series(su)->copy tftp://1.1.1.1/configfilename.txt slot1/configfilename.txt
S-Series(su)->configure slot1/configfilename.txt
This command will reset the system and clear current configuration.
Are you sure you want to continue (y/n) [n]?
     5.Type 'y' and Press Enter
     6.The switch will now reboot and load the new config file
 
Additional notes
Test network connectivity to the TFTP server from the replacement switch via ping. 
Be sure that the IP address used on the replacement switch does not conflict with the existing  switch if on the live network. 
How to Upgrade/BackRev N/S/K/7100 Series Firmware

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255