Reset Search
 

 

Article

How to have an Access Point Name show up in beacons for a site survey report

« Go Back

Information

 
TitleHow to have an Access Point Name show up in beacons for a site survey report
Objective
How to have Access Points Name show up in beacons for a site survey report
Environment
  • IdentiFi 
  • Firmware 9.21.02, 9.15.08
  • Site Survey 
  • AP38xx
  • Ekahau - Site Survey
  • OmniPeek
Procedure
  1. Step 1 - Log into the Wireless Appliance Management GUI and select the AP tab
  2. Step 2 - Select the APs tab from the left hand side 
  3. Step 3 - Select the AP you want to have the beacon advertise in the air
  4. Step 4 - Select the Advanced tab
  5. Step 5 - Change the LED state to Identify (will cause all the LED's to blink), select close, then save
  6. Step 6 - Run the survey tool and capture the ap name
  7. Step 7 - Change the LED back to previous state (default is normal), select close, then save
User-added image
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255