Reset Search
 

 

Article

How to obtain all adopted access points IP addresses from wireless controller CLI

« Go Back

Information

 
TitleHow to obtain all adopted access points IP addresses from wireless controller CLI
Objective
How to obtain all adopted access points IP addresses from wireless controller CLI
Environment
  • Virtual Controller
  • WirelessWiNG Controllers
  • WiNG v5.x Software
  • Wing v7.x Software
  • WirelessWiNG
  • WiNG v5
  • WiNG v7
  • WirelessWiNG Access Points
  • RFS4010
  • NX9XXX
  • NX75XX
  • NX55XX
  • VX9000
  • AP84xx
  • AP85xx
  • AP71xx
  • AP75xx
  • AP76xx
  • AP5xx
  • AP4xx
  • AP3xx
Procedure
Access the wireless controller CLI (Command Line Interface) using 3rd party emulator (e.g. PuTTy).

After successful login and if access points are adopted to wireless controller locally and wireless controller is the rf-domain-manager (RFDM), use the following syntax:


enable [enter]
show adoption status [enter]
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------
DEVICE-NAME       VERSION         CFG-STAT         MSGS ADOPTED-BY        LAST-ADOPTION  UPTIME     IPv4-ADDRESS
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------
AP460                       7.3.1.0-046R    configured       No   VX9-GCP-Pv7         0 days 00:51:45     0 days 00:53:57     192.168.3.60
AP510                       7.3.1.0-046R    configured       No   VX9-GCP-Pv7         0 days 00:51:24     0 days 00:53:59    
192.168.3.61

If access points are in separate rf-domain, use the following:

enable [enter]
show adoption status on rf-domain xxxxx [enter] (x represents the rf-domain name)

 
Additional notes
If access points are not adopted to the wireless controller, you will not be able to obtain the access points DHCP address.

If using static IP addressing on the access points, export the running-config and the IP addresses will be present on the access points at the device level. 

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255