Reset Search
 

 

Article

How to recreate a device default profile on a WiNG device using CLI

« Go Back

Information

 
TitleHow to recreate a device default profile on a WiNG device using CLI
Objective
Learn how to create a default profile for any WiNG devices, when that profile is no longer available in the configuration.
Environment
  • All Summit WM3000 Series Controllers
  • ExtremeWiNG Controllers
  • WirelessWiNG Controllers
  • ExtremeWiNG Access Points
  • WirelessWiNG Acess Points
  • WiNG v5.X Software
Procedure
To recreate the default profile, in this case we use the AP8533 as an example:
#en
#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
#profile ap8533 default-ap8533
#com wr

<< If you want to confirm the values >>

(config-profile-default-ap8533)#show cont
profile ap8533 default-ap8533
 no autoinstall configuration
 no autoinstall firmware
 crypto ikev1 policy ikev1-default
  isakmp-proposal default encryption aes-256 group 2 hash sha
 crypto ikev2 policy ikev2-default
  isakmp-proposal default encryption aes-256 group 2 hash sha
 crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
 crypto ikev1 remote-vpn
 crypto ikev2 remote-vpn
 crypto auto-ipsec-secure
 crypto load-management
 crypto remote-vpn-client
 interface radio1
 interface radio2
 interface radio3
 interface bluetooth1
  shutdown
  mode bt-sensor
 interface ge1
 interface ge2
 interface pppoe1
 use firewall-policy default
 service pm sys-restart
 router ospf
 adoption-mode controller

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255