Prior to reverting the changes, I would recommend making an archive of the running configuration via show config outfile to backup the configuration for later review.
Plese see How to save a configuration on the S Series
1. Disable Netflow
First, review configuration
type 'show config netflow
set netflow export-interval 1
set netflow export-destination 10.258.32.52 2055
set netflow export-destination 10.258.36.212 2055
set netflow export-version 9
set netflow port tg.1.2 enable rx
set netflow template refresh-rate 30 timeout 1
set netflow cache enable
To disable, netflow export, simply to
clear netflow cache
To remove a speciifc port from collection
clear netflow port tg.1.2
2. Disable Policy
to the ports
First, review the configuration via a 'show config policy'
We want to remove the ports applied to the policy. in this case tg.1.2
set policy profile 1 name Purview pvid-status enable pvid 0 mirror-destination 1
set policy rule admin-profile port tg.1.2 mask 16 port-string tg.1.2 admin-pid 1
To remove, enter the following
clear policy rule admin-profile port tg.1.2 mask 16 port-string tg.1.2
3. Disable MirrorN functionality. This is what sends over 15-31 packets of a new flow stream to the Purview collector, either directly or via a GRE tunnel.
First we will want to review the configuration for the policy MirrorN.
type 'show config mirror
set mirror create 1
set mirror 1 mirrorN 15
set mirror ports tg.1.3 1
This can be fully deleted via the command
clear mirror 1
Or via removal of the port
clear mirror ports tg.1.3 1
If the port mirror is not directly connected to the Purview appliance, but instead it goes via a GRE tunnel, then the following can be used to disable.
This will stop the tunnel interface from being operational.