Reset Search
 

 

Article

How to Reset an WiNG APs version running software version 5.x to Factory Defaults via Console Port

« Go Back

Information

 
TitleHow to Reset an WiNG APs version running software version 5.x to Factory Defaults via Console Port
Objective
To reset the configuration of an AP-7522 access point to factory defaults
Environment
  • ExtremeWiNG
  • AP-7522
  • WiNG 5.x
  • All WiNG APs
Procedure
Login to the AP-7522 via console port (baud rate 115200) using the following credentials: 
Login: reset
Password: DefaultFactory
Type "y" when asked if you want to proceed with the task. 

Once the AP-7522 loads the default configuration, you may login to it by using the default credentials. 
Username: admin
Password: admin123

The above will not work if connecting using a Secure Shell (SSH) connection. In this case you can reset the AP by logging in and running the following commands:
>en
#delete startup-config
#Delete startup-config? y
#reload
Additional notes
Please refer to the AP-7522 Access Point Installation Guide for additional details on how to access the management functions of the AP. 
For procedures resetting AP650 or AP6532, please refer to the article How to factory reset WiNG AP650 or AP6532
See also How to restore WiNG Wireless Controllers and Access Points to factory default from CLI

 

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255