Reset Search
 

 

Article

How to setup IdentiFi Wireless Controller physical management interface through CLI

« Go Back

Information

 
TitleHow to setup IdentiFi Wireless Controller physical management interface through CLI
Objective
How to setup IdentiFi Wireless Controller physical management interface through CLI
Environment
  • IdentiFi Wireless
  • Firmware V9.x or Higher
Procedure
  • Use the following syntax for configuration of the esa0 port for management purpose: 
 
EWC.extremenetworks.com# topology
EWC.extremenetworks.com: topology# create "Management" physical 1 port esa0 untag 10.26.0.166/20
EWC.extremenetworks.com: topology# apply
EWC.extremenetworks.com: topology# Management
EWC.extremenetworks.com: topology: Management# l3
EWC.extremenetworks.com: topology: Management: l3# ap-register enable
EWC.extremenetworks.com: topology: Management: l3# mgmt enable
EWC.extremenetworks.com: topology: Management: l3# apply
EWC.extremenetworks.com: topology: Management: l3# exit
EWC.extremenetworks.com: topology: Management# exit
EWC.extremenetworks.com: topology# exit
EWC.extremenetworks.com# ip
EWC.extremenetworks.com: ip# route default 10.26.0.1
EWC.extremenetworks.com: ip# apply
EWC.extremenetworks.com: ip# exit

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255