Reset Search
 

 

Article

How to show adopted access points mac addresses and IP addresses from wireless controller

« Go Back

Information

 
TitleHow to show adopted access points mac addresses and IP addresses from wireless controller
Objective
How to show adopted access points mac addresses and IP addresses from wireless controller
Environment
  • WirelessWiNG Controllers
  • WirelessWiNG Access Points
  • WiNG v5.x Software
  • WirelessWiNG
  • WiNG v5
  • AP84xx
  • AP85xx
  • AP76xx
  • AP505
  • AP510
  • AP82xx
  • AP71xx
  • AP75xx
  • RFS4010
  • NX9XXX
  • NX75XX
  • NX55XX
  • VX9000
Procedure
Access the wireless controller CLI and if the access points are in the same rf-domain as the wireless controller, perform the following:

enable [enter]
show wireless ap [enter]

The following output is an example of the above from Extreme Gtac lab wireless controller:

WiNG-5#show wireless ap
-----------------------------------------------------------------------------------------------------------------------------------------------------
  MODE        : radio modes - W = WLAN, S=Sensor, ' ' (Space) = radio not present
-----------------------------------------------------------------------------------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------------------------------------------------------------
  AP-NAME           AP-LOCATION     RF-DOMAIN        AP-MAC            #RADIOS MODE  #CLIENT          IPv4                                    IPv6
-----------------------------------------------------------------------------------------------------------------------------------------------------
                            ::
  7632-1                            Master_RFS4      D8-84-66-8C-A6-44       2 W-W         1    192.168.3.106                                      ::
-----------------------------------------------------------------------------------------------------------------------------------------------------
Total number of APs displayed: 1

If access points are in a different rf-domain then the wireless controller, perform the following from the wireless controller CLI:

enable [enter]
show wireless ap on xxxxxxxx [enter] (x represents the rf-domain you wish to view)
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255