Reset Search
 

 

Article

How to upgrade a Extreme Wireless Controller with Extreme Management Center

« Go Back

Information

 
TitleHow to upgrade a Extreme Wireless Controller with Extreme Management Center
Objective
To upgrade a Extreme Wireless Controller using Extreme Management Center
Environment
Extreme Managmement Center version 7.03.xx and higher
Procedure
  • From Devices->Select Firmware

User-added image



User-added image
  • Click upload twice
  • Click Refresh once successfully uploaded (see above)
  • Firmware is now deposited in repository
  • Click Devices
  • Select Device->Configuration/Firmware->Upgrade Device

User-added image
  • Select Firmware to use in Firmware Selection Window and then Click OK
User-added image
  • If the firmware image is incorrect, select Image Selection, other Click Start
User-added image

Click Ok at Begin Firmware Download Window
User-added image
The operation should start, Execute SCP operation under Messages, then eventually you should see the following.
User-added image

If it fails, you will need to look at the messages windows for guidance.
This document will not discuss potential failure modes.


 
Additional notes
Note: this methodology Immediately reboots the wireless controller and loads the new firmware. It is not a scheduled reset.

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255