Reset Search
 

 

Article

Where on a WiNG 5 wireless controller can the adopted AP DHCP IP address be located?

« Go Back

Information

 
TitleWhere on a WiNG 5 wireless controller can the adopted AP DHCP IP address be located?
Objective
Where on a WiNG 5 wireless controller can the adopted AP DHCP IP address be located?
Environment
  • WirelessWiNG Controllers
  • WirelessWiNG Access Points
  • WiNG v5.x Software
  • WirelessWiNG
  • WiNG v5
  • AP81xx
  • AP84xx
  • AP85xx
  • AP82xx
  • AP75xx
  • AP76xx
  • RFS4010
  • NX9XXX
  • NX75XX
  • NX55XX
Procedure
If using the CLI (Command Line Interface) from a WiNG 5 wireless controller, perform the following:

From WLC CLI:
 
enable [enter]
show wireless ap [enter]

User-added image

The above is when the APs are in the same rf-domain as the wireless controller (single rf-domain deployment)

When the APs are in different rf-domain then the wireless controller, you will need to use the following from the wireless controller CLI:
 
enable [enter]
show wireless ap on xxxxxx [enter] (x represents rf-domain name)

User-added image

If accessing the wireless controller UI, use the following:

Single rf-domain:

User-added image

Remote rf-domain:

User-added image

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255