Reset Search
 

 

Article

How to configure ospf on a user created virtual router

« Go Back

Information

 
TitleHow to configure ospf on a user created virtual router
Objective
How to configure ospf on a user created virtual router.
Environment
  • All Exos  .
  • Summit x670-G2.
Procedure
conf vlan default del port 1 
conf vr-default del port 1 

create vr london 
create vlan red tag 10 
conf vr london add ports 1 
conf vlan red add port 1 tag 

conf vlan red add ip addoress 10.0.0.1/24 
enable ipforwarding vlan red 
enable loop-back mode red 

conf vr london add protocols ospf 

#vr london <<<<<<---- you need to be in user created vr 

configure ospf add router id ------- 
configure ospf add van red area 0.0.0.0 
enable ospf 

# show ospf interfaces 
VLAN IP Address AREA ID Flags Cost State Neighbors 
red 10.0.0.1 /24 0.0.0.0 -rif--- 10/A DR 0 


# sh vlan 
----------------------------------------------------------------------------------------------- 
Name VID Protocol Addr Flags Proto Ports Virtual 
Active router 
/Total 
----------------------------------------------------------------------------------------------- 
Default 1 --------------------------------T--------------- ANY 0 /51 VR-Default 
Mgmt 4095 ------------------------------------------------ ANY 1 /1 VR-Mgmt 
red 10 10.0.0.1 /24 -fL------o------------------ ANY 0 /1 london 
-----------------------------------------------------------------------------------------------

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255