Reset Search
 

 

Article

How can I validate that beamforming is turned on/off on a WiNG access point ?

« Go Back

Information

 
TitleHow can I validate that beamforming is turned on/off on a WiNG access point ?
Question
How can I validate that beamforming is turned on/off on a WiNG access point ?
Environment
WiNG Access Points
Answer
Transmit-beamforming is enabled by default on WiNG APs.

To check to see if it is disabled you can run the following "show running-config | inc beamforming"

* Expect the output to be blank if it is setting is enable
* If setting is disabled you will see "no transmit-beamforming" in the screen output
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255