Reset Search
 

 

Article

How do I configure PIM on a SecureStack

« Go Back

Information

 
TitleHow do I configure PIM on a SecureStack
Question
How do I configure PIM on a SecureStack
Environment
  • C5-Series
  • 6.81.08.0005
Answer
Sample C5-Series Configuration
C5(su)->router
C5(su)->router>enable
C5(su)->router#show running-config
!
license advanced 140b70a541c7812c
ip igmp
!
ip pimsm
!
ip route 10.10.90.169 255.255.255.255 20.20.12.1
!
interface vlan 1210
no shutdown
ip address 20.20.12.42 255.255.255.252
ip igmp enable
ip ospf areaid 20.20.12.0
ip ospf enable
ip pimsm enable
and to verify Multicast communication 
C5(su)->router#show ip mroute
Active IP Multicast Sources
Flags: D - Dense, S - Sparse, C - Connected, L - Local,P - Pruned, R - RP-bit se
t, F - Register flag, T - SPT-bit set,Outgoing interface flags: H - Hardware swi
tched
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode

Source Network :
Source Mask : 0.0.0.0
MultiCast Group : 239.255.255.250
Uptime : 1264428280
Upstream Neighbor: 20.20.12.57
Upstream Vlan : 1214
Downstream Vlans : 1301
Additional notes
and if you don't see any PIM commands available in the CLI, did you purchase a license?

PIM command not showing up in CLI on Securestack

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255