Reset Search
 

 

Article

Is it possible to create a LAG with a combination of copper and fiber ports in EXOS

« Go Back

Information

 
TitleIs it possible to create a LAG with a combination of copper and fiber ports in EXOS
Question
  • Can i create a LAG with a combination of copper and fiber ports in EXOS?
Environment
  • EXOS ALL
  • Summit & BlackDiamond
  • LAG with UTP and Fiber
Answer
  • Yes, it is possible to create a sharing group consisted on copper and fiber ports as long as both ports have same speed and duplex.
For example:
* X460G2-[R1:U7]-[34].23 # show ports 27-28 configuration no-refresh
Port Configuration
Port     Virtual    Port  Link  Auto   Speed      Duplex   Flow  Load   Media
         router     State State Neg  Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
27       VR-Default  E      A    ON  AUTO  1000 AUTO FULL    SYM        BASET
28       VR-Default  E      A    ON  AUTO  1000 AUTO FULL    SYM        SX
================================================================================

* X460G2-[R1:U7]-[34].28 # enable sharing 27 grouping 27,28 algorithm address-based L3
Warning: Any config on the master port is lost (STP, IGMP Filter, IGMP Static Group, MAC-Security, CFM, TRILL etc.)

* X460G2-[R1:U7]-[34].29 # show sharing
Load Sharing Monitor
Config    Current Agg     Min    Ld Share  Dist  Ld Share  Agg Link  Link Up
Master    Master  Control Active Algorithm Flags Group     Mbr State Transitions
================================================================================

    27            LACP       1    L3        A     27        yes    A       2
                                  L3              28        yes    A       2
================================================================================

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255