Reset Search
 

 

Article

AP622 failed to broadcast SSID after upgrading to 5.9.0.2

« Go Back

Information

 
TitleAP622 failed to broadcast SSID after upgrading to 5.9.0.2
Symptoms
  • Radio 2 enabled as a 2.4Ghz data radio
  • Radio 1 turned off
  • After upgrading Radio 2 do not broadcast SSID
Environment
  • WiNG 5.9.0.2
  • APs that end with “-EU”.
Cause
This note applies to the following APs that end with “-EU”. These APs are sold to countries that comply with the EU directives - AP 622, AP 6522, and AP 6562. This does not apply to APs that end in “-US” or “-WR”
  • Radio 1 will support operation as a 2.4Ghz data radio compliant with ETSI 1.7.1 adaptivity directive
  • Radio 2 cannot be enabled for operation as a 2.4Ghz data radio. Radio 2 will support operation as a 5Ghz data radio only
  • If using Radio 2 in 2.4Ghz, please enable Radio 1 for data access in 2.4Ghz
  • When Radio 2 is configured as a dual-band security sensor with an ADSP appliance;
  • Radio 2 will not support Air Termination, AP Test, and Network Assurance at 2.4Ghz band
  • Radio 2 will support receive packet and forensic security analysis at 2.4Ghz band
  • Radio 2 will support Air Termination, AP Test, Network Assurance and all packet receive functions on the 5Ghz band
Resolution
Revert the AP to WiNG version 5.5.1 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255