Reset Search
 

 

Article

Auto-provision remains enabled even after the configuration is saved

« Go Back

Information

 
TitleAuto-provision remains enabled even after the configuration is saved
Symptoms
The following symptoms are seen after saving the config on a "factory default" switch (where "unconfig switch all" command is issued and the switch is rebooted")

The following message is seen in the logs -

12/17/2018 09:58:40.91 <Warn:BOOTP.Client.AutoPrvsnDHCPUnrch> The DHCP Server is unreachable through VR VR-Mgmt.

Auto-provision remains enabled even after saving the configuration on a switch that is at factory default.

Switch # show auto-provision
-------------------------------------------------------
VR-Name     Auto-Provision Status  Number of attempts
-------------------------------------------------------
VR-Default   Enabled (InProgress)  701
VR-Mgmt      Enabled (InProgress)  8731
Environment
Summit All
Blackdiamond All
EXOS All
Cause
This behavior is changed from EXOS 22.5 onwards
Resolution
Workaround 1: Manually disable auto-provisioning by issuing the "disable auto-provision" command.
Workaround 2: Configure an IP address for MGMT or Default VLAN which would automatically disable auto provisioning.
Workaround 3: Rebooting the switch would disable auto-provisioning.
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255