- Port partition needs to be configured to select what partition speed you want to use for 100G link (whether its going to be 1 x 100G, 2 x 50G or 4 x 25G) after selecting the partition template to use 4x100G ports.
L2:U34.1 # configure port 57 partition ?
1x100G Partition 100G port into one 100G port
1x40G Partition 40G port into one 40G port
2x50G Partition 100G port into two 50G ports
4x10G Partition 40G port into four 10G ports
4x25G Partition 100G port into four 25G ports
L2:U34.13 # configure ports 57 partition 1x100G
Warning: Configuration will be lost on ports 57
No configuration changes should be made on these ports until after
the next reboot.
This command will only take effect after save configuration and reboot.
- Once the configuration are saved and switch is rebooted, port 57 will come up with 100G speed.
L2:U34.1 # show configuration hal
# Module hal configuration.
configure ports partition-template 4x100G slot 1
configure ports 57 partition 1x100G