Can't find what you need?


• Ask the Community
• Create a Case
Reset Search
 

 

Article

Default user config change for SNMPv3 is shown under "show config snmp" and not under "show config snmp detail"

« Go Back

Information

 
TitleDefault user config change for SNMPv3 is shown under "show config snmp" and not under "show config snmp detail"
Symptoms
When an SNMPv3 user is deleted and added back, it is showing under 'show config snmp' rather than being hidden under 'show config snmp detail' output. This is a cosmetic issue which does not impact the SNMP config. In this case, customer had SNMPv3 access disabled which means SNMPv3 is not active.

1) default config:

x670G2.6 # show config snmp
#
# Module snmpMaster configuration.
configure snmpv3 delete community "private"
configure snmpv3 delete community "public"
configure snmpv3 add target-addr "v1v2cNotifyTAddr1" param "v1v2cNotifyParam1" ipaddress 10.1.1.1 transport-port 162 tag-list "defaultNotify"
configure snmpv3 add target-params "v1v2cNotifyParam1" user "v1v2cNotifyUser1" mp-model snmpv2c sec-model snmpv2c sec-level noauth
disable snmp access snmpv3


2) Deleting the user which adds additional line in the config (This is expected behavior).

x670G2.7 # show config snmp
#
# Module snmpMaster configuration.
#
configure snmpv3 delete user "admin" engine-id 80:00:07:7c:03:00:04:96:9b:d4:e6
configure snmpv3 delete community "private"
configure snmpv3 delete community "public"
configure snmpv3 add target-addr "v1v2cNotifyTAddr1" param "v1v2cNotifyParam1" ipaddress 10.1.1.1 transport-port 162 tag-list "defaultNotify"
configure snmpv3 add target-params "v1v2cNotifyParam1" user "v1v2cNotifyUser1" mp-model snmpv2c sec-model snmpv2c sec-level noauth
disable snmp access snmpv3


3) Adding the user back should remove it from 'show config snmp' and put it under 'show snmp config detail' but its not happening.


x670G2.8 # show config snmp
#
# Module snmpMaster configuration.
#
configure snmpv3 add user "admin" engine-id 80:00:07:7c:03:00:04:96:9b:d4:e6
configure snmpv3 delete community "private"
configure snmpv3 delete community "public"
configure snmpv3 add target-addr "v1v2cNotifyTAddr1" param "v1v2cNotifyParam1" ipaddress 10.1.1.1 transport-port 162 tag-list "defaultNotify"
configure snmpv3 add target-params "v1v2cNotifyParam1" user "v1v2cNotifyUser1" mp-model snmpv2c sec-model snmpv2c sec-level noauth
disable snmp access snmpv3
Environment
  • EXOS All
  • EXOS 15.7 - 22.1
Cause
This is a software defect which is being tracked via CR# xos0068683.
Resolution
CR# xos0068683 is currently assigned and will be fixed in next EXOS 16.2 and 21.1 releases.
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255