Reset Search
 

 

Article

How to configure DHCP services useing CLI on WiNG Access Points.

« Go Back

Information

 
TitleHow to configure DHCP services useing CLI on WiNG Access Points.
Symptoms
DHCP service is not running.
Environment
  • Any WiNG AP
  • WiNG 5.x.x
Cause
Swift UI in 5.7.x has a known issue in configuring DHCP services
Resolution
Configure the DHCP services in CLI
 
WLC#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
WLC(config)#dhcp-server-policy vlan1
WLC(config-dhcp-policy-vlan1)#dhcp-pool vlan1
WLC(config-dhcp-policy-vlan1-pool-vlan1)#network A.B.C.D/M  Network number and Mask
WLC(config-dhcp-policy-vlan1-pool-vlan1)#network range x.x.x.x y.y.y.y
WLC(config-dhcp-policy-vlan1-pool-vlan1)#default router A.B.C.D Router's IP address
WLC(config-dhcp-policy-vlan1-pool-vlan1)#​dns-server x.x.x.x

WLC(config-dhcp-policy-vlan1-pool-vlan1)#commit write

Apply the newly created DHCP policy
WLC(config)#self
WLC(config-device-B4-C7-99-6D-CF-45)#use dhcp-server-policy vlan1
WLC(config-device-B4-C7-99-6D-CF-45)#commit write


 

 


 
    Additional notes
    APs with swift/express UI need upgrade firmware version to 5.8.x above in order to be able to create the DHCP server policy in the GUI.

    Feedback

     

    Was this article helpful?


       

    Feedback

    Please tell us how we can make this article more useful.

    Characters Remaining: 255