Reset Search
 

 

Article

K10 Spontaneously Rebooting After Three -Five Minutes

« Go Back

Information

 
TitleK10 Spontaneously Rebooting After Three -Five Minutes
Symptoms
  • Chassis continues to reset every 5 minutes
  • Removal of failed blade stabilizes chassis
  • Log messages seen in "show support"
  •  
  • Message 74/234 Syslog Message 08.62.02.0022 04/02/2017 09:40:51
    <3>System[11]Restarting the line card in slot 7 ( KT2006-0224 pn 9404352
    , sn 12490124685H ) due to a detected failure
    
    ==============================================================================
    Message 75/234 Syslog Message 08.62.02.0022 04/02/2017 09:40:50
    <3>NIM[11.tNismProc]Line card in slot 7 ( KT2006-0224 pn 9404352, sn 12
    490124685H ) initialization failure... Failed to configure switch chip.
    (0xffffffff,0x00000000)
    
    ==============================================================================
    Message 76/234 Syslog Message 08.62.02.0022 04/02/2017 09:40:50
    <3>Fuji[11.tNismProc]fujiSpauiLinkStatusCheck: Fuji 12 SPAUI link check
    failed.
    
    ==============================================================================
    Message 77/234 Syslog Message 08.62.02.0022 04/02/2017 09:40:50
    <3>Fuji[11.tFujiAge]fujiAgeTransId: Fuji=12, adr=0x60900038, transId=0,
    seqNum=1 write access timeout
    
    ==============================================================================
    Message 78/234 Syslog Message 08.62.02.0022 04/02/2017 09:40:31
    <3>Fuji[11.tNismProc]fujiInit: Fuji 12 Stonehenge/Hammer training failed
    .
    
    ==============================================================================
    Message 79/234 Syslog Message 08.62.02.0022 04/02/2017 09:40:31
    <3>Fuji[11.tNismProc]fujiStonehengeHammerInterfaceTraining: Calibration
    timed out for Slave Id 6.

 
Environment
  • K-Series
  • Firmware 08.62.02.0022
Cause
Replace Bad  Hardware
Resolution
This message is a hardware fault

If seeing symptoms described in this article then the next step is to submit an RMA.
 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255