Reset Search
 

 

Article

OSPF neighbor adjacency is "Full" but not adding routes into route table.

« Go Back

Information

 
TitleOSPF neighbor adjacency is "Full" but not adding routes into route table.
Symptoms
OSPF neighbor adjacency is "Full" but not adding routes into route table.
Environment
  • K-Series
  • S-Series
  • 7100-Series
  • All firmware versions
  • OSPF
Cause
One side of the adjacency is configured as a "point-to-point" connection and the other is not.
Resolution
Correct the configuration so that the sides match one another:

EXOS:
configure ospf delete vlan <Vlan>
configure ospf add vlan ,Vlan> area <area> link-type <correct link-type>

EOS:
interface vlan NUMBER
ip ospf network point-to-point
#or
no ip ospf network point-to-point

Cisco:
router
config
interface vlan <VLAN_ID>
ip ospf network point-to-point
#or
no ip ospf network point-to-point

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255