Reset Search
 

 

Article

Static radio channel settings are not redeployed after an ExtremeWireless Access Point factory reset, firmware version 10.41.07.

« Go Back

Information

 
TitleStatic radio channel settings are not redeployed after an ExtremeWireless Access Point factory reset, firmware version 10.41.07.
Symptoms
  • Static radio channel settings are not redeployed after an ExtremeWireless Access Point factory reset, firmware version 10.41.07.
  • Radio channels are set to 36/1 or 36/6 after a factory reboot.
Environment
  • ExtremeWireless appliances
  • All ExtremeWireless Access Points
  • firmware 10.41.07.
Cause
A configuration is sent to the Access Point with a fixed channel width, but no channel value. This was not supported properly by the Access Point after a factory reset.
Resolution
Please upgrade to 10.41.09.
Additional notes
Release Note: wns0020687 - Resolved corner case whereby if AP was previously configured with Auto Channel and fixed channel width, if a factory reset occurred the AP would be stuck on channel 36 @ 20MHz.

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255