Reset Search
 

 

Article

Summit 100FX Link issue with Source Photonics SPG-FE-FX-CDFC-EX

« Go Back

Information

 
TitleSummit 100FX Link issue with Source Photonics SPG-FE-FX-CDFC-EX
Symptoms
  • Issue getting a connection and passing traffic. 
  • The transceiver is connecting at 1000Mbps when it is only a 100Mbps device. See output below. 
->show ports configuration no-refresh
Port Configuration
Port     Virtual    Port  Link  Auto   Speed      Duplex   Flow  Load   Media
         router     State State Neg  Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
1        VR-Default  E      R   OFF   100  1000 FULL FULL   NONE        100FX       
2        VR-Default  E      A   OFF   100  1000 FULL FULL   NONE        100FX       
3        VR-Default  E      R   OFF   100  1000 FULL FULL   NONE        100FX       
4        VR-Default  E      R   OFF   100   100 FULL FULL   NONE        100FX   
  • The debug output shows the Vendor part number which is potentially suspect: 
X460G2-48x-10G4.8 # debug hal show optic-info
Port                       1
SFP or SFP+:               SFP
Signal:                    not present
TX Fault:                  no
SFP/SFP+ Vendor:           SOURCEPHOTONICS
SFP/SFP+ Part Number:      SPGFEFXCDFCEX   (the old part number was SPGFEFXCDFBEX)
SFP/SFP+ Serial Number:    16373-80010    
SFP/SFP+ Manufacture Date: 160906 
SFP/SFP+ Type:             SFP/SFP+
Connector:                 LC
GE Compliance:             100BASE-FX
Wavelength:                1310
Environment
  • Summit Series. 
  • Part number & Rev of units impacted: 10063/900412-10 Rev 05 or greater.
 
 
Cause
New hardware on transceiver required code update to accommodate
Resolution
Upgrade to EXoS 22.2.1.5 or later
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255