Can't find what you need?


• Ask the Community
• Create a Case
Reset Search
 

 

Article

VX9000 continuously panicking and entering in diag mode after alias configuration change on GUI

« Go Back

Information

 
TitleVX9000 continuously panicking and entering in diag mode after alias configuration change on GUI
Symptoms
After configuring a set of aliases under the rf-domain using the user interface, if we set more than 15 different protocols under the same rule, the VX9000 enters in diag mode after few panics.
User-added image
Environment
  • All Summit WM3000 Series Controllers
  • ExtremeWiNG Controllers
  • WirelessWiNG Controllers
  • ExtremeWiNG Access Points
  • WirelessWiNG Acess Points
  • WiNG v5.9.X Software
Cause
CLI only allows you to configure 15 different protocols under the same rule, an example below:
#alias network-service $VLAN proto icmp proto tcp 110 proto tcp 143 proto tcp 443 proto tcp 995 proto tcp 21 proto tcp 80 proto tcp 5222 proto tcp 993 proto tcp 465 proto tcp 587 proto udp 53 proto udp 123 proto udp 4500 proto udp 500

 
Resolution
As a workaround, you can split the protocols in two different rules, so you can reach more than 15 rules, as the example below:
alias network-service $VLANA proto icmp proto tcp 110 proto tcp 143 proto tcp 443 proto tcp 995 proto tcp 21 proto tcp 80 proto tcp 5222 proto tcp 993 proto tcp 465 proto tcp 587 proto udp 53 proto udp 123 proto udp 4500 proto udp 500
alias network-service $VLANB proto tcp 880 proto udp 3478 proto udp 5353

 
Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255