Reset Search
 

 

Article

Why can't I remove the static route from the controllers config?

« Go Back

Information

 
TitleWhy can't I remove the static route from the controllers config?
Symptoms
The correct commands are being used and changes saved, but the static route persists and is still present in the startup-config.
Environment
  • WiNG 5.x
  • RFS series controllers
  • NX series controllers
  • VX series controllers
  • WiNG APs (non legacy)
Cause
The command to remove the static route is being invoked in the controllers profile while the static route has been configured as an override. 
Resolution
  1. Login to the controller via SSH (Secure Shell) using an SSH client such as Putty.exe or through the console port (baud rate: 19200 or 115200)
  2. Run the following commands:
>en
#self                       
Enter configuration commands, one per line. End with CNTL/Z.
#show context              (make sure you see the static route here)
#no ip <network IP/and subnet mask> <Default Gateway IP address>
(Example: #no IP 192.168.1.0/24 192.168.1.254)
#com wr
#show context              (make sure that the static route has been removed)
Additional notes
Please contact our technical support team should further assistance be required.  

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255