Reset Search
 

 

Article

arp-sender-address rule installation fails when "ipmcforwarding ipv6" is enabled on the switch.

« Go Back

Information

 
Titlearp-sender-address rule installation fails when "ipmcforwarding ipv6" is enabled on the switch.
Symptoms
  • Switch is showing below error while applying ACL on port or on vlan.
Switch.1 # configure access-list Deny_Inside ports 1-12 ingress
..
Error: ACL install operation failed - filter hardware full for vlan *, port 12


Switch.2 # configure access-list Deny_Inside vlan "VLAN_1001_L2"

Error: ACL install operation failed - filter hardware full for vlan VLAN_1001_L2, port *
  • configured ACL precedence as shared, but still the switch is showing the same error.



 
Environment
  • Summit X670-G2-72x
  • EXOS 16.2.5.4-patch1-7
     
Cause
The Error is seen due to improper allocation of the UDF-ids for some rule in the ACL. 
Resolution

This issue is fixed in EXOS 30.3.1 as per the CR xos0075854

Additional notes

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255